1/29/2024 0 Comments Kess v2 vs mpps v18![]() ![]() ![]() Gf191 Location Offline Junior Member Reputation: 0. If not, do not waste money in your pocket. Magpro2 x17, Kess v2, K-tag, Galletto v54, mpps v18, vcds, vcp, autocom. So, if you read and write from OBD port and program with Jtag, BDM and Boot protocols, you must go to KESS + KTAG together. Many ECU has the advantage that can be read and write from OBD port (so KESS V2 is perfect), but there are lot ECU that need to disassemble from the car and open and this is the case for all the ECU that need to be programmed with Jtag, BDM and Bootprotocols, so KTAG is needed. With KESS V2 you programming directly through the OBD port of the vehicle, while with Ktag you need to take apart the ECU and open it, after you can make the read/write operation. Open ksuite and in protocol menu select boot St Once in there select Bosch MED 7 29F400. How to use MPPS V18 to read/write EDC17C46 through BOOT: You need to take the ECU apart and connect resistors etc to the circuit board. Put it into boot mode by grounding pin 24. For those wanting to read/write and ecu containing the AM29F400, AM29F800 chip with kess v2 just follow theses steps. The new ECUs have been tested using MPPS v18 ECU flasher cable for the tricore/boot wires. KESS V2 is a ECU programming tool that is perfect for OBD use, while KTag is perfect for Jtag, BDM and all the Boot application (tricore and ST10). I’ve managed to do it by a kess v2 as well. The new MPPS V18 clone supports K-line, CAN-L, CAN-H, MAIN + TRICORE + MULTIBOOT to program a wide range of ECUs like M3.8, M5.9, ME7xx, MED9, MED17, EDC15/16/17, Delphi, Siemens, Marelli, Delco, Sagem, Trionic and many othersincluding the Marelli ECU. ![]() VERY IMPORTANT TIPS: you’d better read it before your purchase Ktag 7.020 adds 100+ ECU types& supports new car models e.g. Ktag 6.070 supports BDM MOTOROLA MPC5xx, and BMW Gasoline F Chassis and Mercedes W222 (M)EDC Flash checksum, (M)EDC Eeprom checksum, Simos PCR, Simos 8, Simos SID305…. Tricore Boot: add new file checksum utility for tricore, now supports: Mpps v18 adds OBD: Volvo ME7/EDC15C11, Bentley ME7.1.1, VAG ALL TDI Bosch EDC17 X UDS drive (EDC17C46 and EDC17C64 ECUs.), Generic Tricore VAG Only Multi ECU – MPPS Container file flasher. MPPS coversMAIN + TRICORE + MULTIBOOT and a wide range of controllers incl. MPPS v18 works for obd2,Multiboot, Tricore for Marelli ECU’s MPSS V18 clone vs Ktag firmware 7.020 vs Kess V2 firmware 5.017: differences among functionality. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |